• Solvent free
• Non toxic
• Long pot life
• Negative hydrostatic pressure resistant
• Temperature Resistance from -40°C up to 90°C
• Excellent mechanical properties, high tensile and tear strength, abrasion resistance.
• Inhibits fungal and bacterial growth
• Warm water resistance 60°C - 90 °C
• Excellent chemical resistance
• Negative hydrostatic pressure resistant
• 1 to 12mm thickness in one single coat
• Crack bridging

• Continuously flexible floors
• Industrial Floors
• Ship Decks
• Hospitals and Pharmacy floors
• Living areas and Showrooms
• Pharmaceutical Industries floors
• Food, Chemical and Pharmaceutical Industries
• Hotels, Shops and Supermarkets
• Offices,Schools and colleges
• In food and beverage industry
• Indoor Car Parks
• Refrigeration cells and Tanks
• Healthcare area floors
• Secondary containment
• Electronics store floors
• Asphalt floors

Indicatively around 1,3 kg/m²/mm of thickness.

Concrete substrate conditions (standard):
Hardness: R28 =15 MPa
Humidity: W < 10%
Temperature: from (+5 °C to +40 °C)
Relative humidity: < 80%
Remove from the floor oil, grease ,wax contaminants,cement laitance, loose particles, mold and release agents
The application surface must be dry.
Fill surface irregularities with adequate products. Primer must be applied on relatively fresh concrete or in cases where negative pressure may cause the material to bubble. In these cases,either apply several coats of EpoxyPRIMER® 2K our water based epoxy primer can be charged with sand as described in the respective technical data sheet.
For substrates that need to be made stronger, the one component penetrating primer Primer® D-1K should be used.

Mixing FlexDEC® 2K
Start mixing component A+B and use a low speed (300 rpm) electric drill until the mixture is completely homogenous.

Apply FlexDEC® 2K As Self-Leveling;
Depending on demand, 1 to 10 mm thickness can be applied in a single coat.
Apply undiluted with a notched trowel, squeegee or roller.
As soon as the material is applied, use a spiked roller to remove entrapped air.

Topcoat
FlexDEC® 2K is a polyurethane system and therefore will be very low discolor when exposed to UV. For color protection, traffic/abrasion resistance as well as providing an easy clean and unique final satin finish , we recommend our Full aliphatic water-based TopcoatDEC® SF-2K product for 100% resistance to sunlight and surface scratches.

Cleaning
Clean your tools and equipment with Cellulosic thinner during the application phase.